hestan AKMWCK Manuel D'installation page 5

INSTALLATION INSTRUCTIONS
STEP 1 CABINET OR WALL OPENING
Provide an opening in the wall or cabinet as indicated
in Figure 1. The depth should be a minimum of 20-1/8"
[51.1 cm]. If the Depth (E) dimension is greater than
21" [53.3 cm], the outlet location may be in any area
on the rear wall. The floor of the opening should be
constructed of plywood strong enough to support the
weight of the oven - approximately 100 lbs. [45kg], and
should be level for proper operation of the oven.
NOTE: While the proper function of the oven does
not require that the opening be enclosed (with sides,
ceiling and rear partition), this may be required by local
code, and it is suggested that the local code be checked
for any such requirement.
The opening in the wall or cabinet must be within
the following dimensions, centered horizontal to the
cabinet.
AKMWCK27
A 20" [50.8 cm]
B 26-7/8" [68.3 cm]
C 18-1/2" [47 cm]
D 25-1/4" [64.1 cm]
E Min. 20-1/8" [51.1 cm]
F 5" [12.7 cm]
G 10" [25.4 cm]
STEP 2 EXHAUST DUCT ASSEMBLY
A. Insert the edge of DUCT (B) into the hold lip of
DUCT (C). Secure together by using a SCREW (I)
provided in the kit. See Figure 2.
DUCT (B)
SCREW (1)
Figure 2
(CONT.)
Outlet should
indicated on Figure 1.
NOTE:
than 21" [53.3 cm], the outlet location may be any
area on the rear wall.
AKMWCK30
20" [50.8 cm]
29-7/8" [75.9 cm]
NOTE:
should be 90˚ to front
18-1/2" [47 cm]
cabinet frame.
25-1/4" [64.1 cm]
Min. 20-1/8" [51.1 cm]
5" [12.7 cm]
10" [25.4 cm]
B. Position DUCT (A)-1 on the top of the oven
inserting edge of DUCT (BC) assembly into hole
lip of DUCT (A)-1. Tighten two SCREWS (I),
securing DUCT (A)-1 to DUCT (BC) assembly.
See Figure 3.
DUCT (C)
SCREW (I)
NOT be in the shaded area as
If the dimension of DEPTH (E) is more
F
C
A
D
B
Floor of opening
[87.6 cm] MIN.
Figure 1
DUCT (BC)
Figure 3
©2019 Hestan Commercial Corporation
G
FLOOR
E
34-1/2"
FLOOR
DUCT (A)-1
SCREW (I)
3
EN