Before Operating; To Set The Clock - hestan KMWR30 Manuel D'utilisation Et D'entretien

INTRODUCTION
CONTROLS CONTROLS
The following illustration depicts the control panel and shows the page numbers to find
EN
information about each item.
21
WARM
21 19

BEFORE OPERATING

Before operating your new Drawer Microwave make sure you read and understand this operation
manual completely.
• Before the Drawer Microwave can be used, follow these steps:
1. Plug in the Drawer Microwave.
CLOCK
2. Touch the
3. Set clock as follows:

TO SET THE CLOCK

TO SET THE CLOCK
4. Touch
5. Touch number pads for correct time of day and touch
This is a 12 hour clock. If you attempt to enter an incorrect clock time,
display. Touch the
• If the electrical power supply to your Drawer Microwave should be interrupted, the display will
intermittently show
after the power is reinstated. If this occurs during cooking, the program will be erased. The
time of day will also be erased. Simply touch
correct time of day.
NOTE:
• The Drawer Microwave can be programmed with the drawer open except for
minute
TIMER TIMER
1. Touch
2. Enter time.
3. Touch
To cancel timer, touch
12
©2021 Hestan Commercial Corporation
(CONT.)
18 14 15 14
KEEP
WARM
19 20 16 18
Numbers next to the illustration indicate pages on which
there are feature descriptions and usage information.
will appear.
pad.
STOP/CLEAR
pad and number
TIMER/CLOCK
pad and re-enter the time.
STOP/CLEAR
ENJOY YOUR
.
pad and number
TIMER/CLOCK
pad again.
TIMER/CLOCK
STOP/CLEAR
21
13
ENJOY YOUR MICRO- WAVE
will appear.
:
.
2
TIMER/CLOCK
MICRO- WAVE TOUCH
STOP/CLEAR
.
1
.
13
TOUCH CLEAR AND
pad again.
will appear in the
ERROR
CLEAR AND TOUCH
pad and reset the clock for the
/
START
13
12
TOUCH
CLOCK
add