Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
AC Power
This product has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC
50 Hz, depending on the specific model.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Resetting the Breaker
This product is equipped with a resettable circuit breaker. If the breaker trips, all sections of this product will lose power.
1.
Remove the power cord from main power.
2.
Allow unit to cool for 15 minutes.
3.
After 15 minutes, you may attempt to reset the breaker by pressing the button with your finger.
4.
Plug the product's power cord into the power outlet and continue using as recommended.
DMX Linking
The Vesuvio II will work with a DMX controller using a 3- or 5-pin DMX data connection for its 15-channel DMX
personality. A DMX Primer is available from www.chauvetprofessional.com.
DMX Connection
The Vesuvio II uses a 3- or 5-pin DMX data connection for its 15-channel DMX personality. See the User Manual for
information about connecting and configuring the product for DMX operation.
Preparing for Operation
To prepare the Vesuvio II for operation:
1.
Pull out the fluid tank and remove the cap.
2.
Verify that the two plastic hoses attached to the inside of the cap are in place and in good condition.
3.
Pour Chauvet (QDF) fog fluid inside the tank, and re-cap.
4.
Make sure that the plastic hose that goes from the cap to the fogger is not bent.
5.
Reinsert the tank.
6.
Plug in power and wait approximately 7 minutes for warm-up to complete.
When storing the product, ALWAYS be sure to store the fluid tank with the cap up as seen on the
Product Mounting Diagram before installing the front cover to avoid tube damage that may cause
leakage.
Only use Chauvet approved (QDF) fog fluid. Otherwise, you might not have satisfactory results.
In addition, unapproved fluid can damage the Vesuvio II or cause harm to humans or animals.
2
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
Screw Color
Yellow/Brass
Silver
Green
Vesuvio II QRG Rev. 2
Publicité
Table des Matières
