Change Grinding Disc - HOLZMANN MASCHINEN DSM 150 Mode D'emploi

Always check the gap between tool rest and grinding stone. It should be around ~ 1-2mm.
When grinding dry, you should always wear safety goggles.
Check the fixing nut of the grinding stone regularly if tightened well.
If the machine is used frequently, we strongly advice to connect the grinding machine to a
dust collection system suitable for collecting metal dust.
You should maintain the surface of your grinding stone in regular intervals.
Use for example the HOLZMANN TDSSA 45 diamond T-dresser
5 MAINTENANCE
Clean the machine after every working session! Do not use a pressure air system, you just
would just raise the dust into the air.

5.1 Change grinding disc

Remove the red protection cover with a screwdriver.
Fix the grinding stone and loosen the fixing nut on the arbour. Remove the fixing nut and the
flange.
Remove the old grinding stone and install the new one, place the flange onto the stone and fix
it with the nut. Install the red protection cover back.
Let the machine now run in test mode for one minute and check the stone for any vibration,
out-of-balance run.
No maintenance, checks, cleaning or upkeep as long as machine is connected
to the power supply:
Risk of unintended starting up!
Therefore: Disconnect the machine from the power supply.
A C H T U N G