Timer; Program Pause - DJO Global cefar basic Mode D'emploi

8. THE STIMULATION STARTS
The program starts after a few seconds, and the amplitude is automatically adjusted to an optimal level
of stimulation.
42
Even if you use Auto stimulation mode, you can increase or decrease the amplitude at any time by
pressing the INCREASE or DECREASE buttons
so, the automatic amplitude setting is lost.

TIMER

The preset treatment time is set to 30 minutes, but the timer function allows you to set the treatment
time yourself. You have the option to change the timing from "- -" to 60 minutes. If you choose to stay
on "- -", the stimulation will go on until you stop the stimulation manually.
To set the timer:
1. Select a program and start the stimulation, see section STEP-BY-STEP USE.
2. Press the TIMER button
3. Increase the time by pressing the right INCREASE button
each time you press the button. Decrease the time by pressing the right DECREASE button
The time is decreased by 1 minute each time you press the button. The time is flashing on the display,
while setting the timer.
4. Press the TIMER button

PROGRAM PAUSE

You can pause the programs up to 5 minutes.
To pause a program:
1. If key lock is on, press any of the DECREASE buttons
2. Press the PROGRAM button
Start stimulation again by pressing the PROGRAM button
If stimulation is paused for more than five minutes, the stimulator turns off automatically to spare bat-
teries.
to initiate the timer function.
AUTO AUTO
S
P
to confirm the timer setting.
AUTO AUTO
S
P
AUTO AUTO
to pause the program.
S
P
until the stimulation feels pleasant. If doing
AUTO AUTO
S
P
. The time is increased by 1 minute
AUTO AUTO
S
P
to deactivate it.
AUTO AUTO
.
S
P
AUTO AUTO
S
P
.
AUTO AUTO
S
P