Operation; Step-By-Step Use - DJO Global cefar basic Mode D'emploi

5. OPERATION

STEP-BY-STEP USE

40
1. INSERT THE BATTERIES
Insert the batteries (see chapter REPLACEMENT OF BATTERIES).
2. ATTACH THE ELECTRODES
A. Connect the electrodes to
the cable.
3. SWITCH THE STIMULATOR ON
Press the ON/OFF button
minating the stimulation at all times, even when the key lock is acti-
vated.
Always switch the stimulation off before removing electrodes from
the skin.
4. SELECT A PROGRAM (1-3)
Press the PROGRAM button
your choice is shown on the display.
Note! When selecting programs the amplitude must be set to 00.0
mA for both channels.
For further information on the programs, see section PROGRAM
GUIDE.
B. Attach the electrodes to
your body.
. This button can be used for ter-
AUTO AUTO
P S
AUTO AUTO
repeatedly until the program of
S
P
C. Connect the cable to the
CEFAR BASIC.