Hama 00054177 Mode D'emploi page 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following
instructions and information completely. Please
keep these instructions in a safe place for
future reference. If you sell the device, please
pass these operating instructions on to the
new owner.
1. Explanation of Warning Symbols and
Notes
Warning
This symbol is used to indicate safety
instructions or to draw your attention to
specific hazards and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• USB Car Charger
• USB 2.0 Type-C-Cable 3A
• These operating instructions
3. Safety Notes
• The product is intended for private, non-
commercial use only.
• Protect the product from dirt, moisture and
overheating and use it in dry rooms only.
• Do not drop the product and do not expose it
to any major shocks.
• Do not operate the product outside the power
limits given in the specifications.
• Do not open the device or continue to
operate it if it becomes damaged.
• Do not modify the device in any way. Doing
so voids the warranty.
• Do not continue to operate the device
if it becomes visibly damaged. (This is
mandatory for all products with 220 V mains
connections.)
Note
• When using this product, observe
the applicable local traffic laws and
regulations.
• Take care that components such
as airbags, safety areas, controls,
instruments, etc. and visibility are not
blocked or restricted.
4. Operation
N
ote – USB-A port
• The USB port on the power supply unit
can be used to charge or operate USB
devices such as tablet PCs, smartphones,
MP3 players, navigation devices, etc. The
maximum output current of the USB-A
port is 2000 mA.
2
N
ote – Power Delivery
• Plug & go: No manual setup necessary,
just connect and start:
Voltage and power are automatically
configured by Power Delivery.
• For efficient and optimised charging, the
Power Delivery (PD) function must be
supported by your terminal device.
• With the large quantity of PD-enabled
terminal devices with different firmware
versions, it can happen that the function
is not fully supported.
W
arning – Connecting
USB-C terminal devices
• Ensure that your notebook, tablet PC,
smartphone or console requires a power
supply voltage of 5 / 9 / 12 / 15 / 20 volts
(+/- 1 V).
• The specified supply voltage can be
found on the original power supply unit
or in the user manual of your device.
• Ensure that the total power consumption
of the notebook, tablet PC, smartphone
or console does not exceed the power
supply unit's rated output capacity
of 70 W.
Unless the operating instructions for the
devices you want to charge explicitly inform you
otherwise, proceed as follows:
• With the device switched off, connect it to
the charger.
• Plug the charger into a car socket in the
vehicle electrical system.
• Do not switch on the device for further use
until you have done this.
When charging batteries built into a device, pay
attention to the maximum charging time for
the batteries. Disconnect all cable and mains
connections after use.
Note
For some vehicle types, the ignition has to
be switched on to supply power to the car
socket. For more information, please refer to
your vehicle's manual.
5. Care and Maintenance
Only use dry, soft cloths for cleaning.
Note
Disconnect the device from the power supply
before cleaning or if it will not be used for a
long period of time.