Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR DISCHARGING GAS EMISSIONS
Type "A" Appliances (see data plate)
Type "A" appliances must discharge the products of combustion into extractor hoods or similar devices connected to
and efficient chimney, or directly outside. (Natural Discharge Fig.1)
If there is not a hood, as an alternative, an air extractor connected directly to the outside is acceptable, (Forced
Discharge Fig.2) but its capacity must not be inferior to what is established in item 4.3 of the UNI-CIG norm 8723.
In the event of forced discharge
The gas supply the appliance, must be directly interlocked to the system and must cut off automatically in the event that
its capacity goes below the values prescribed by item 4.3 of the UNI-CIG norm 8723.
The release of gas to the appliance must be possible only manually.
NATURAL DISCHARGE Fig.1
1) Extractor hood
Daily cleaning after switching off the appliance ensures the perfect functioning and long life of the appliance. The parts
in steel must be cleaned with a detergent-soaked cloth without rubbing; after that, rinse with clean water and dry with a
dry cloth. If the surface of the hotplate is not used for some time, it must be covered with a fine film of oil.
WHAT TO DO IN THE EVENT OF BREAKDOWN
Turn off the gas tap and notify the after sales service.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR
Turn off the gas tap, clean the installation as specified above.
GB
IE
CLEANING AND MAINTENANCE
SOME TIME
27
FORCED DISCHARGE Fig.2
1) Extractor hood
2) Interlocking
Publicité
Chapitres
Table des Matières
