Technical Data And Drawings; Technical Data Table; Transformation; Instructions For Installation - Lotus cooker FT T-64ET Série Instructions Pour L'installation Et L'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

The data plate is attached to the back panel (see drawing electrical connection point) and contains all the information

necessary for connection.

MODELS

DIMENSIONS cm POWER SUPPLY

FT*T-64ET**

40x60x29h

60x60x29h

FT*T-66ET**

FT*T-68ET**

80x60x29h

FT*T-610ET**

100x60x29h

FTCT-64ET

40x60x29h

FTCT-66ET

60x60x29h

MODELS

DIMENSIONS cm POWER SUPPLY

FT*T-64ET**

40x60x29h

FT*T-66ET**

60x60x29h

FT*T-68ET**

80x60x29h

FTCT-64ET

40x60x29h

FTCT-66ET

60x60x29h

FT*T-66ET**

60x60x29h

FTCT-64ET

40x60x29h

60x60x29h

FTCT-66ET

*L = Smooth hotplate – R = Corrugated hotplate - L/R = ½ Smooth +1/2 Corrugated

**S= Chromium-plated hotplate

The data plate is on the side of the appliance (see figure A) and has all the data necessary for the connection.

When fitting, the appliance must be levelled using a spirit level; slight differences of level can be adjusted by screwing

or unscrewing the adjustable feet. The main switch or the socket must be near the appliance and easily accessible.

It is advisable to place the appliance under an extractor hood so that steam is extracted rapidly. If the appliance is placed

near walls, dividing panels, kitchen furniture, decorative finishing, etc., these should be in flameproof material;

otherwise it is necessary to cover them with non-flammable material.

Above all, it is necessary to ensure that the fire prevention norms are observed.

Attention! This appliance has been produced for use as part of a battery. If used singly, it will be necessary to keep it at

least 10cm away from the adjacent walls.

Installation must be carried out observing the following norms:

- Safety prescription in force

- Installation prescription, norms in force.

The installation, starting up and maintenance of the appliance must be carried out by qualified personnel. All operations

done when installing must be carried out observing the norms in force.

The manufacturer declines all responsibility in the event of incorrect functioning due to wrong installation or

installation which does not comply with the norms.

Attention! In accordance with international rules, when connecting the appliance, an automatic device enabling the

disconnection of all contacts from the mains, must be installed above it; this device must have a contacts opening of at

least 3 mm.