Starting Up Glass Ceramic; Special Indications Glass Ceramic; Cleaning And Maintenance; Cleaning And Maintenance Glass Ceramic - Lotus cooker FT T-64ET Série Instructions Pour L'installation Et L'emploi

GB IE
The appliance is equipped with a temperature limiting device that acts when the temperature reached can damage the
glass
Warning
Prevent the glass from being hit, above all by objects with corners and points.
Be careful never to cover the glass with sheets of aluminium paper or similar material during use.
Fry tops are appliances for cooking meat, fish, eggs, vegetables, cheese, etc.

STARTING UP GLASS CERAMIC

Before using the appliance for the first cooking, it is necessary to clean it carefully (see paragraph "cleaning and care").
Check the connection of the appliance and start it up following the instructions.
When using the hotplate for the first time, it is advisable to let all the hotplates work for a few minutes at maximum
power, in order to remove any humidity from the insulating mass of the elements.
When using the oven for the first time, it is advisable to take out all the removable parts and to heat it up, to a
temperature of 250°C.

SPECIAL INDICATIONS GLASS CERAMIC

When the glass ceramic fry-top is in use is recommended to clean the glass and remove all the remains that deposit
using the special spatula or a damp cloth

CLEANING AND MAINTENANCE

Attention: when cleaning do not wash the outer casing with direct or high pressure jets of water.
At the end of each working day clean the appliance thoroughly. Daily cleaning ensures long life and efficiency for your
appliance. Before carrying out cleaning operations, switch off at the mains, Wash the steel parts with warm water and
neutral detergent, rinse well to eliminate all trace of the detergent, then dry with a soft cloth. Do not use abrasive or
corrosive cleaners. All particles of food must be removed from the grill by means of spatula. The surface must be
thoroughly cleaned then oiled with vegetable oil. Remove the oil container, empty and wash carefully.

CLEANING AND MAINTENANCE GLASS CERAMIC

Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
Cleaning the crystal
The crystal must be cleaned with degreasing liquids, acids containing vinegar and lemon, suitable for cleaning ceramic
and crystal. It is advisable to carry out this operation when the crystal is not completely cold, so that spilled food,
burned grease, etc. can be softened using a damp cloth and removed whilst still warm with an ordinary scraper, in order
to avoid damaging the crystal surface.
Do not use abrasive or corrosive detergents.

PREPARATION FOR A PROLONGED OUT OF USE

Thoroughly clean and dry the appliance as per instructions, switch off at the mains.

INSTRUCTIONS IN THE EVENT OF FAULTS

If a fault develops, turn off the appliance, switch off at the mains and call the technical assistance service.

MAINTENANCE (FOR QUALIFIED FITTERS ONLY)

Any maintenance operations must be carried out exclusively by qualified fitters. Before commencing maintenance
operations or repairs, disconnect the appliance or turn off at the mains. Empty the pan if necessary.
24