Maintenance Instructions - Lance Lab AR 8 Manuel D'utilisation

Maintenance Instructions: AR 8
EN
Adjustable Telescopic Lance
Replacing a damaged pole section:
When ordering a replacement pole section, they are referenced (AR8-01 to
AR38-07), with section 1 (AR8-01) being the handle (thickest) and section 7
(AR38-07) being the top section connecting to the powder chamber.
1. Using a sharp blade or knife, cut the
end of the main hose kit approximately
10cm from the end of the trigger
connection valve.
(KEEP BOTH PARTS ONCE CUT FOR
3. Pull the rubber end foot off the lance.
Push the rubber seal & washer back.
4. To replace the sections 5, 6 or 7, cut
off the plastic threaded powder chamber
connector from top section 7 (AR38-07)
using a sharp blade or hacksaw.
-12-
REUSE).
Only do this when
replacing sections
Cut
5, 6, or 7.
here.
2. Remove the main tubing by pulling
through the lance. (KEEP FOR REUSE).
*Please note*
If replacing sections 1, 2, 3, or
4 (AR8-01 - AR8-04) please skip
steps 4 and 7. But proceed as
normal with steps 5, 6 and 8.
If replacing section 5, 6 or 7
(AR8-05, ARL38-06, AR38-07)
then please proceed to step 4.
Note: Replacement Sections
5, 6 and 7 come with a new
plastic threaded powder
chamber connector and rubber
gasket.
5. Remove the damaged section
from the lance.