Samsung RF28JBEDBSG/AA Mode D'emploi page 21

• To change the water filter more easily,
shut off the water supply valve.
• Sometimes, it is hard to disassemble the water
filter because impurities in the water cause it
to stick. If you are having difficulties, grip the
water filter firmly and pull it hard.
• When you pull the water filter, a little water
can leak from the opening. This is normal.
To minimize the water leaks, keep the filter
cartridge horizontal when you pull it.
• To prevent overflow, empty the water tray filter
( 3 ) and dry around of case filter ( 2 ).
3. Insert the new filter into the filter case ( 4 ).
4. Push the filter, and then turn it clockwise until
it locks.
• If you have trouble inserting the water
filter because of high water pressure,
shut off the water supply valve.
• The locked symbol should be lined up with the
indicator line.
DA68-02952B-04.indb 21
( 2 )
( 3 )
( 4 )
English - 21
5. Touch and hold the "Alarm / hold 3 sec for
Filter Reset" button (
3 seconds to reset the water filter indicator.
The indicator's red light will turn off.
6. If you turned off the water supply, turn it back
on.
For a replacement water filter, visit your
local home Improvement center or visit
Samsung's parts distributor on line at:
http://www.samsungparts.com
Be sure the replacement water filter has
the SAMSUNG logo on the box and on the
water filter.
Removing any residual matter inside
the water supply line after installing
the water filter.
1. Turn ON the main water supply and supply
water from water supply line.
2. Run water through the dispenser until the
water runs clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.
3. Additional flushing may
be required in some
households.
4. Open the Refrigerator
door and make sure
there are no water
leaks coming from the
water filter.
Be sure to flush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
) for about
(Filter Reset)
2016. 3. 30. 1:33