Bartscher K7GFG0515A Mode D'emploi page 55

Electronic board (for models with electronic control)
To replace the electronic board open the doors of the compartment. Remove the box under the tank
as follows: remove the fixing screws and take out the upper cover turning it to the back side and to
the right one and pay attention to the cables. Take out the flat connexion to the display and remove
the component from the stirrup on which it is hooked.
Heating elements (fig.24-25-26 pag. 8)
To substitute the heating elements open the compartment door, then remove the heating element
protection (1) unscrewing the fixing screws (2) slightly. Then unscrew the connectors that fix the
thermostat extensions (3), remove the clips (4) that fix the thermostat to the heating element and
dismantle the bulb support (5); then remove everything. Then unscrew the screws (6) that fix on the
handle (7) for the rotation of the heating element then remove it from inside the vat after
disconnecting it.
WHEN SUBSTITUTING, ONLY ORIGINAL SPARE PARTS SUPPLIED BY THE
MANUFACTURER MUST BE USED. THE OPERATION MUST BE CARRIED OUT BY
AUTHORIZED PERSONNEL.
ATTENTION! If the substitution operation has involved gas system components the tightness
of the gas system and correct functioning of the various components must be checked.
THE MANUFACTURER RESERVES THE RIGHT TO WITHOUT NOTICE MODIFY
THE FEATURES OF THE APPLIANCES DESCRIBED IN THIS MANUAL.
Pag. 54/87