Sharp SKMD30E9ES Instructions D'installation

30" EXTENSION KIT: SKMD30E9ES
IMPORTANT NOTES TO THE INSTALLER
• Read all of the Installation Manual that is included with the Microwave Drawer before installing the extension kit.
• Observe all governing codes, ordinances, and safety instructions.
• Be sure to leave these instructions with the consumer.
Parts included:
Left Side Trim (qty. 1)
Install the extension kit after properly installing the microwave drawer in the cabinet. See steps below.
Note that the side trims are marked "L" and "R" on the back side.
MICROWAVE DRAWER STANDARD MOUNT, MEASUREMENTS AND INSTALLATION INSTRUCTIONS
F
Figure 1
Right Side Trim (qty. 1)
B
A
C
J
I
D
H
E
INSTALLATION INSTRUCTIONS
Mounting Brackets (qty. 2)
A. 21 / " (549.28 mm)
5
8
B. 4 / " (119.06 mm)
11
16
C. 1 3 / " (44.45 mm)
4
D. 21 / " (555.63 mm)
7
G
8
E. 23 / " (600.07 mm)
5
8
F. 16" (406.4 mm)
G. 14 / " (370.68 mm)
19
32
H. 1 / " (38.89 mm) door thickness
17
32
I. 15" (381 mm) auto drawer opening
J. 4" (101.60 mm)
E 1
Trim Screws (qty. 4)
Bracket Screws (qty. 8)
TINSK B289 MRR0