Publicité
Les langues disponibles
Les langues disponibles
No oven shown
Suggested
electrical
outlet location
A. 22
/
" (562.0 mm) mounting cleat opening
1
8
width
B. 30
/
" (769.9 mm) minimum
5
16
30
/
" (777.9 mm) maximum
5
8
C.
/
" (3.2 mm) from opening to top of shelf
1
8
2. Place the drawer adjacent to the wall or cabinet opening. Plug
the power supply cord into the electrical outlet.
3. Carefully guide the drawer into the prepared opening. Avoid
contact with the sides of the cutout opening and pinching the
cord between the oven and the wall.
4. Slide the drawer all the way back until the side rails touch the
cleats mounted in the cabinet opening.
5. Open the drawer. Using the 4 holes on the drawer as a template,
pre-drill the cabinet using a
with the 4 screws supplied. See Figure 5.
A
Anti-Tip block
B
C
Front view
Figure 4
/
" (1.6 mm) bit. Secure the drawer
1
16
Side
Rail
Figure 5
6. Close drawer to complete oven installation. See Figure 6.
7. Remove the 2 trim screws from each mounting bracket to begin
installation.
Note: The mounting brackets come assembled to the side
trims.
8. Properly align brackets to microwave side rails. See Figure 7.
Bracket
Side rails
Align sides and bottom of the 30"
mounting brackets to the sides and bottom
of the microwave drawer side rails
E 5
Figure 6
Figure 7
Publicité
