Inglesina Tolomeo 2.3 IFIX Manuel D'instructions page 14

passes gently over his shoulder. You will need to
adjust this position as the child grows.
INSTALLING THE CHILD CAR SEAT
7/8 WITH THE ISOFIX CONNECTORS AND
THE VEHICLE SAFETY BELT
7.1 If your vehicle is equipped with Isofix
anchor points, these should be used to
obtain a more stable installation.
Use the isofix plastic guides provided with the
child car seat if your vehicle does not have them.
Caution: When the seats of your car are
equipped with Isofix anchor points, install your
child car seat using your vehicle's ISOFIX anchor
points ALWAYS and ONLY in combination with
the vehicle's safety belts. See the vehicle list.
8.1 Place the child car seat in the appropriate
position on the vehicle's seat, facing in the
direction of travel.
8.2 Rotate the adjuster lever (10) and
simultaneously pull the isofix connectors (9)
outwards as far as they go. Make sure that they
cannot be pushed backwards.
8.3 Position the child car seat facing forwards
on the vehicle seat with isofix points.
8.4 Match the isofix connectors (9) to the
vehicle's anchoring point until you hear a "click".
The display window will change from red to
green.
8.5 Rotate the adjuster lever (10) and
simultaneously push the child car seat against
the vehicle seat backrest to eliminate the gap
between child car seat and vehicle's seat.
ATTENTION!
Isofix connectors are an additional fitting
system for securing the child car seat and are
not suitable for securing a child.
Child must always be secured by means of the
vehicle's three-point safety belt.
SECURING CHILD IN THE CHILD CAR
9
9.1 Place your child in the child car seat and
make sure he is sitting correctly.
9.2 Insert the vehicle's seat belt through the
belt guide under the headrest (6) and the belt
guide under the armrest (8).
9.3 Pass the diagonal section of the vehicle's
seat belt through the belt guide under the
headrest (6).
9.4 Pass the lap section of the vehicle's seat belt
through the seat belt guide under the armrest
(8) next to the seat belt buckle.
9.5 Ensure that no part of the vehicle'a seat
14
SEAT
belt has become twisted or trapped and that
the child car seat's fabric cover doesn't interfere
with the movement or correct fitting of the
vehicle's seat belt.
INSTALLATION OF CHILD CAR SEAT IN THE
VEHICLE
10. Ensure that the diagonal belt lies gently
on the child's shoulder and the lap belt is worn
over the hips. Tighten the diagonal section of
the vehicle's seat belt by pulling it upwards until
there is no slack and the belt holds the child
firmly in place.
To take the child out of the child car seat, simply
unfasten the vehicle's seat belt and undo the
shoulder belt guide.
CHECK OF THE SAFETY BELT POSITION
11. To ensure the best protection for your child,
the shoulder belt must be guided so that it
passes gently over their shoulder. You will need
to adjust this position as the child grows.
HOW TO REMOVE THE CHILD CAR SEAT
12. To remove the child car seat, pull the grey
button backwards on the Isofix anchors to
release the child car seat from vehicle's Isofix
anchor points.
ATTENTION!
If you have difficulty to release the Isofix
connectors, try to give a bit more force to
the child car seat against the vehicle's seat
and simultaneously to pull the grey button
backwards on the Isofix connectors to release
the child car seat. This may help, if not, please
consult Manufacturer or your Retail stores.
HOWTO ADJUST THE HEADREST
13. To adjust the height of the child car seat's
headrest (1), pull upwards on the lever situated
behind the headrest (5), and slide the headrest
in the desired direction.
When you reach the correct height, release the
lever (5) and move the headrest until it reaches
the closest blocking position. When done
correctly, you should hear a "click".
HOW TO REMOVE THE SEAT COVER
14. Remove the headrest cover by pulling it
forward and off.
15. Remove the wings cover by pulling them
forward and off.
16. Push the backrest to make it flat down.
17. Remove the base cover by pulling it forward