Getting Started - Furrion FDHS32M1A Manuel D'instructions

Getting Started

The Setup Wizard window appears the first
time you turned on the TV. It will assist you
to configure the TV and scan for available
channels.
IMPORTANT: Make sure the antenna or cable
TV system connection is made.
1. Press POWER button on the TV control
panel or button on the remote control
to switch on the TV. The power indicator
will change to green. The Setup Wizard
window appears on the screen.
NOTE: It may take a few seconds before
the Setup Wizard window appears on the
screen.
key to highlight TV Location,
2. Use or
then press
or
Store Mode.
NOTE: When you select Store Mode it will
remind you Store Mode consumes more
energy. Select Yes to enter or No to cancel.
to highlight Go to next step,
Press or
press OK or to go to the next step.
3. Use or key to highlight Menu
Language, then press
desired language.
to highlight Go to next step,
Press or
press OK or to go to the next step.
to select Home Mode or
to select the
or
4. Use or key to highlight Time Zone, then
press to select desired time zone.
or
key to highlight Daylight Saving
Use or
Time, then press
key to highlight Time Format, then
Use or
press to select 12-hour or 24-hour.
or
to highlight Go to next step,
Press or
press OK or to go to the next step.
5. Use or key to highlight Air/Cable,
then press
or
base on your connection.
to highlight Go to next step,
Press or
press OK or to start the auto scan.
The Setup Wizard will scan for available
channels automatically. The scanning may
take some time.
to select On or Off.
or
to select Air or Cable
14