Before Operation; What's In The Box; Preparation Of Your Remote Control - Furrion FDHS32M1A Manuel D'instructions

Before Operation

What's in the box

Thanks for purchasing this Furrion HD LED
TV. This manual will help you set up and
begin using your TV. Please read this manual
thoroughly and keep this manual in a safe
place for future reference.
First, check the contents of your box with the
parts checklist below:
For Model FDHS32M1A
● HD LED TV
● Unimote
● AAA battery × 2
● Instruction Manual
● Warranty Card
● Wall-mount screws x 4 (PWM 5x8 mm)
● TV Stand
● 4 x Screws for TV stand (BBH 4x15 mm)
For Model FDFS40M1A
● HD LED TV
● Unimote
● AAA battery × 2
● Instruction Manual
● Warranty Card
● Wall-mount screws x 4 (PWM 6x12 mm)
Now you can get started!
Preparation of your Remote
Control
BATTERY INSTALLATION
1. Open battery compartment cover.
13
2. Install two AAA batteries.
3. Close the cover of the battery compartment.
NOTE: Use two "AAA" size batteries. The
batteries may last approximately one year
depending on usage. For best performance,
it is recommended the batteries should
be replaced on a yearly basis, or when the
remote operation becomes erratic. Do not
mix old and new batteries or different types.
BATTERY PRECAUTIONS
These precautions should be followed when
using batteries in this device:
● Use only the size and type of batteries
specified.
● Be sure to follow the correct polarity when
installing the batteries as indicated in the
battery compartment. Reversed batteries
may cause damage to the device.
● Do not mix different types of batteries
together (e.g. Alkaline and Carbon-zinc)
or old batteries with fresh ones.
● If the device is not to be used for a long
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
● Do not try to recharge batteries not
intended to be recharged; they can
overheat and rupture (follow battery
manufacturer's directions).
● Please use caution when inserting
batteries to avoid battery damage. If the
spring terminal in the remote control
remains in contact with a side of a
damaged battery it can cause a short
circuit. Never use damaged batteries
as they can become very hot and are
dangerous.