Getting Started; Setup Wizard - Furrion FDUS50M7A Manuel D'instructions

Getting Started

The Setup Wizard window appears the first
time you turned on the TV. It will assist you
to configure the TV and scan for available
channels.
IMPORTANT: Make sure the antenna or
cable TV system connection is made.
1. Press POWER button on the TV control
panel or button on the remote control
to switch on the TV. The power indicator
will change to green. The Setup Wizard
window appears on the screen.
NOTE: It may take a few seconds before
the Setup Wizard window appears on the
screen.
to to select Home Mode
2. Use or
(Energy Saving) or Standard Mode.
Press OK to enter the next menu.
3. When you select Home Mode, Use
to select Yes or No. Press OK to enter
the next menu or press MENU to return to
the previous menu.
4. Use /
your desired settings.
Menu
Language
Air/Cable
Cable
System
Auto Scan
or
NOTE: You may press MENU at any time to
exit the menu.
*The Setup Wizard will scan for available
channels automatically. The scanning may
take some time.
/ / to navigate and select

Setup Wizard

to highlight Menu
Use or
Language, then press
select English, French or Spanish.
Use or to highlight Air/
Cable, then press or
Air or Cable.
to highlight Cable
Use or
System, then press
select Auto, STD, IRC or HRC.
NOTE: Only adjustable when "Air/
Cable" is set as "Cable" mode.
Use or to highlight Auto
Scan, then press OK or
scanning all the channels available
in your area.
or to
to select
or to
to start
15