Getting Started - Furrion FDFS40M4A Manuel D'instructions

Getting Started

The Setup Wizard window appears the first
time you turned on the TV. It will assist you
to configure the TV and scan for available
channels.
IMPORTANT: Make sure the antenna or
cable TV system connection is made.
1. Press POWER button on the TV control
panel or button on the remote control
to switch on the TV. The power indicator
will change to green. The Setup Wizard
window appears on the screen.
NOTE: It may take a few seconds before
the Setup Wizard window appears on the
screen.
key to highlight TV Location,
2. Use or
then press or
or Store Mode.
NOTE: When you select Store Mode it
will remind you Store Mode consumes
more energy. Select Yes to enter or No to
cancel.
Press or to highlight Go to next
step, press OK or
key to highlight Menu
3. Use or
Language, then press
desired language.
Press or to highlight Go to next
step, press OK or
to select Home Mode
to go to the next step.
or to select the
to go to the next step.
4. Use or key to highlight Time Zone,
then press or
time zone. Use
Daylight Saving Time, then press
to select On or Off. Use
highlight Time Format, then press
to select 12-hour or 24-hour. Press
to highlight Go to next step, press OK
or to go to the next step.
key to highlight Air/Cable,
5. Use or
then press or
base on your connection.
Press or to highlight Go to next
step, press OK or
The Setup Wizard will scan for available
channels automatically. The scanning may
take some time.
to select desired
or key to highlight
or
or key to
or
to select Air or Cable
to start the auto scan.
or
15