Troubleshooting; Installing The Winstyler T180 Software; Pc-Printing - Ricoh 180 Manuel D'utilisation

Installing the WinStyler T180 Software

Different Language Printer Driver was Installed
Cause
The Regional Settings is not the same as
the language of the OS that you are using.

PC-Printing

If there is a problem, the WinStyler T180 Status Display will often provide infor-
mation about the nature of the problem and also offer technical advice on how
to fix it.
Machine does not Print
Cause
Is the power on?
Is the interface cable properly connected? Connect the interface cable properly. If
Are you using the correct interface cable? Be sure to use the correct one. If the cable
Did you connect the interface cable after
turning on the main switch?
Can you print a test page?
The "Printer is busy" message appears on
your display.

7. TROUBLESHOOTING

Solution
Check the Regional Settings and set it to
the preferred language. Uninstall the
WinStyler T180. Reinstall the WinStyler
T180.
Solution
Turn on the machine.
there any connectors or screws, make sure
they are fastened securely.
is damaged or worn, replace it with a new
one.
Make sure to connect the interface cable
before turning on the main switch.
If you can't, your machine might be out of
order. Consult your local service person-
nel.
Wait a few minutes before attempting to
print again.
21