Ribimex Ribiland 97cc Manuel D'instructions Et D'utilisation page 28

IMPORTANT: A continual idling or operation without water in the pump will lead to its damage.
So before starting the engine, please make sure that the pump has been refilled water.
If the suction hose strainer appears above the water in the course of operation, stop the engine as
soon as possible.
2. Make sure that the joint of the suction hose is tightened. Otherwise the air leakage will lead to
no suction or have effect on the power of the pump.
3. Do not install a valve or tap on the discharge hose.
If you proceed with such installation in order to control the water flow, then never turn off the
valve or tap during operation
4. Water will not be pumped if the discharged hose is obstructed, the sudden great pressure created
inside the pump may damage the pump.
5. If the pump is installed in a location where the discharge hose is likely to be stepped on or
pressed, please ensure to cover it with suitable protective covering.
6. Be sure to install the attached filter (strainer) at the head of the suction hose when it is in use.
7. Set the suction hose filter (strainer) under the water, but never allow it to touch the mud or sand.
8. Before use, please check whether each part is loosened or there is any petrol dripping in the fuel
tank.
9. Before starting the engine, make sure that there is no object that can get wet near the pump.
Remind all bystanders around it that the machine will start working
4.5- Starting the engine
1. Turn the fuel valve (a) ON
Fig.11
3. Turn the engine switch (5) to ON position.
Fig.13
2. Completely close the choke lever (14) to OFF
position.
Remark: do not use the choke if the engine is warm or
the ambient temperature is high
4. Move the throttle lever downward slightly, just past
the idle position.
Fig.12
Fig.14
Page 28 of 54