VibroShaper VibroLegs Mode D'emploi page 7

REMOTE CONTROL BUTTONS (Illustration 3)
Power button: Press this button to turn the device ON or OFF.
Start/Stop: Press this button to start your chosen settings. When the device is in operation, press this
button to stop it.
Time -: Reduces the time. The pre-set time is 10 minutes, divided into 10 levels. Press this button to reduce
the time. Only possible before starting the manual programs P1 and P4.
Time +: Increases the time. Press this button to increase the time. The maximum possible time is 10
minutes. Only possible before starting the manual programs P1 and P4.
Speed +: Increases the speed. The speed can be manually set between 1 and 10. Press this button to
increase the speed while the device is running. Only possible during manual program P1 and P4.
Speed -: Reduces the speed. The speed can be manually set between 1 and 10. Press this button to reduce
the speed while the device is running. Only possible during manual program P1 and P4.
Button (Quick button): press this button to quickly switch between speed levels 3, 6 and 9 in manual
programs P1 and P4.
Program Button: Press this button to select a program. You can choose between the programs P1, P2, P3 and
P4. In manual program P1 only the oscillation is activated. In the automatic programs P2 and P3, oscillation
Figure 3
and acupressure alternate according to a predefined scheme. In the manual program P4, oscillation and
acupressure are activated continuously. In the manual programs P1 and P4 you can set the time (1-10 min.) before program start
and the speed levels (1-10) during operation.
The remote control has a range of 2.5 metres. For optimum signal transmission, make sure that there are no obstacles
between the device and the remote control, and point the remote control at the infrared receiver on the device.
Important notes on operation:
• Program P1 is the default when you turn on the device. To start it press
• Stop the device by first pressing
• In programs P1 and P4, you can set the time before starting acupressure and adjust the speed during acupressure.
PROGRAMS
Table 1: Program overview
Oscillation only
STANDARD TIME 10 MINUTES TOTAL
1st minute
2nd minute
3rd minute
4th minute
5th minute
6th minute
7th minute
8th minute
9th minute
10th minute
M20161_Vibrolegs_Manual_20190920_BS.indd 7
. Then switch off the device with the power button
Manual program P1
Automatic program P2 (speed & time pre-defined)
FUNCTION
Oscillation only
Oscillation and acupressure
Oscillation only
Oscillation and acupressure
Oscillation only
Oscillation and acupressure
Oscillation only
Oscillation and acupressure
Oscillation only
Oscillation and acupressure
or choose another program with the P button.
or press again to continue the operation.
Time before program start adjustable (1-10 min.), speed during
program adjustable (level 1-10)
Speed varies every second between levels
Speed & time pre-defined and not
SPEED RANGE
1-10
modifiable
20.09.19 09:44
7