Start-Up And Use - VibroShaper VibroLegs Mode D'emploi

15. If the power cord is damaged, it must be replaced; this should only be done by an authorized and
qualified person.
16. To avoid the risk of electric shock, do not use the device on wet skin.
17. Keep the product away from moisture. Do not use if the appliance or parts of it are wet or damp.
18. The device may be used by children from 8 years of age, or by persons with reduced physical, sensory
or mental capabilities or lack of experience and/or knowledge, only if they have been supervised or
instructed in the safe use of the device and have understood the hazards arising therefrom. Children
should not play with the appliance. Cleaning and user maintenance must not be performed by children
unless they are over 8 years old and supervised. Children younger than 8 years of age are to be kept
away from the machine and the connecting cable.
19. To avoid injury and irreparable damage, always sit while using the massager. In order to avoid serious
injury, never stand on the unit or use it with excessive force.
20. Do not attempt to disassemble or repair the appliance. Repairs may only be carried out by a suitably
qualified technician.

START-UP AND USE

The device is designed for use on the arches of the feet, on the legs, and on the back. Do not use upon the waist,
neck or other parts of the body not described in this manual. Do not use the device for any purposes other than those
specified in this manual.
1. Plug the power adapter into the power outlet and connect the cord to the device. As soon as the device is connected to the
power, it will beep once and the display will light up.
2. Once the device is connected, turn it so that the display faces forward. As soon as you press the
device / the remote control, P1 appears on the display. To start the program, press the
or the Start button (device). To select another program press the P button until the desired program is shown on the display.
To start, press the Start / Stop button (remote control) or the
3. To switch off the device, you must first stop the device by pressing the
remote control. Then press the
4. Disconnect the device from the power outlet after use.
ATTENTION: For sensitive floor surfaces (e.g. parquet) we recommend placing a firm mat or carpet under the unit. This prevents
damage to and discolouration of your flooring.
CORRECT POSITIONS FOR USE (Figure 2)
Place the arch of the foot or calf on the appliance. For use on the back, you can place your back on it or lean against it.
NOTE: Never put your full body weight on the appliance, as this could damage the device.
6
M20161_Vibrolegs_Manual_20190920_BS.indd 6
Power button to switch off the device completely.
Start / Stop button (remote control)
Start button (device).
Stop button on the device or the
Fig. 2
Power button on the
button on the
20.09.19 09:44