Bang & Olufsen BeoVision 1 Mode D'emploi page 30

VIDEO = audio/video mode.
ON (T*10) = shows how many times the set has been turned on from stand by.
(T*10) = The numbers are stated in interval of 10 (e.g. 10 = 100).
The number is given in full tens.
The values are stored in the EEPROM. If faulty readings of the values in the EEPROM
occur all service counter values will be set to 0.
SOUND ADJUSTMENTS
LEFT and RIGHT TREBLE/BASS are for future use.
AVC = Automatic Volume Control, can be set to OFF when measuring in the audio
circuits. The AVC is set to ON when the TV has been turned off by means of the
mains switch.
AVC = Automatic Volume Control, can be set to OFF when measuring in the audio
circuits.The AVC is set to ON when the TV has been turned off by means of the
mains switch.
- MAX VOLUME LIMIT: Can e.g. be used to limit the max. volume regulations on TV´s
placed in hotel rooms.
- Software version for the Digital Surround Decoder (AC3). Is only shown if an AC3
decoder is present in the TV.
TELETEXT ADJUSTMENTS
WSS STATUS: Used for automatic switching to Digital Dolby Surround Sound if there
is WSS codes in the signal.
BROADCAST ONLY: Only switching on signal from the TV tuner.
DETECT ON: Switching on signals from all sources TV tuner, DVD playback, V TAPE
and AV sockets.
DETECT OFF: Used under certain conditions, e.g. a poor signal-to-noise ratio, the
detection may fail, which may entail faulty swithing.
Selecting "B&O LANGUAGE" makes it possible to choose among 7 different teletext
character sets.
0 English, German, Swedish, Italian, French, Portuguese, Slovak
1 Polish, German, Swedish, Italian, French, Croatian, Slovak, Rumanian
2 English, German, Swedish, Italian, French, Portuguese, Turkish
3 English, Russian, Estonian, Czech, German, Lithuanian, Ukrainian
4 English, German, Swedish, Italian, French, Portuguese, Turkish, Greek
5 English, Arabic, French
6 English, Hebrew, Arabic
If language 3 to 6 are choosen it is not possible to receive teletext level 2.5 d/r/c/s
characters.
If language 3 to 6 are choosen it is not possible to make animation in the programme
list in teletext mode.
M2 INFORMATION
- Software versions for the teletext processor 1IC200 SDA6000.
- STB TIMER: Is default set to 0 but can be altered if timing problems occours during
start up with certain Set Top Boxes.
- HW STATUS: For factory use
Service Mode, English 5.9