Xpelair Simply Silent DX100 Serie Instructions D'installation Et D'entretien page 9

10. Insert the fan tube into the wall duct/ceiling
as before.
11. Fasten the back-plate to the wall/ceiling
using appropriate fasteners supplied. See
figure A.
12. If using screws, do not over tighten.
Mount the back draft shutter
13. Peel the backing from the foam strip
supplied and attach it around the outside lip
on the backdraft shutter.
14. Go outside. Holding open the top and bottom
vanes insert the lip into the wall duct.
15. Making sure that the back draft shutter is
level, mark the positions of the two fixing
holes in the top right hand and bottom left
hand corners.
16. Remove the back draft shutters from the
H
FAN
TERMINALS
FAN
TERMINALS
FAN
TERMINALS
ON/OFF
SWITCH
(REQUIRED)
LAMP
(IF REQUIRED)
ON/OFF
SWITCH
(OPTIONAL)
LAMP
(IF REQUIRED)
For fixed wiring circuits the protective fuse
for the appliance must not exceed 5A.
wall duct.
17. Drill screw holes in marked positions and fit
the remaining wall plugs.
18. Holding open the top and bottom vanes,
refit the back draft shutter and fasten
it to the wall using the screws. Do not
overtighten screws.
19. Make sure that the vanes open and shut fully.
Wire the electrical connections.
20. Make sure the mains supply is isolated.
Switch off the mains electrical supply and
remove fuses.
21. Feed the cable to the terminal block. Wire
the fan as shown in Figure H using the
diagram appropriate to the fan model.
22. Connect the cable from the isolating switch
to the electrical supply wiring.
DX100R/DX100S
DX100PR/DX100PS
DX100PIRR/DX100PIRS
FUSE
DOUBLE POLE
ISOLATING SWITCH
DX100TR/DX100TS
FUSE
DOUBLE POLE
ISOLATING SWITCH
DX100HTR/DX100HTS
DX100HPTR/DX100HPTS
FUSE
DOUBLE POLE
ISOLATING SWITCH