Kuzar HAMMER 73 Manuel D'emploi page 5

Industrial Lifter HAMMER 73 Manual in ENGLISH
4. USER INSTRUCTIONS.
4.1 - With the lifter in vertical position, bring down all the aluminium profile by turning the winch han-
dle anti-clockwise. Then take out the "transport blocking piece" located on the side of the lifter and
turn it clockwise until it blocks the last aluminium profile. Thus any movement of the profiles will be
impossible.
4.2 - Place the transport handle (T) in a horizontal position and lock it with the pin and the clip (Figu-
re 4.2.1), then tilt the lifter to place it horizontally on the rubber wheels (Figure 4.2.2).
4.3 - Once the lifter is in horizontal position, take the pin (P) out of the transport position hole (B)
(Figure 4.3.1). Then procede to tilt or bring down the frontal leg (FL) until you place it in its working
position. Put the pin inside the working position hole (W) to block any movement of the leg (Figure
4.3.2). Repeat this step for both legs.
Figura 4.3.1
Figura 4.2.1
FL
W
B
T
P
Figura 4.2.2
Figura 4.3.2
P
KUZAR SYSTEMS S.L. 5