Kuzar HAMMER 73 Manuel D'emploi page 4

Industrial Lifter HAMMER 73 Manual in ENGLISH
3.9 - NEVER allow any team member below the load or anybody else in
the lifts operating zone.
3.10 - Be careful with all obstacles above the lift and its extension zone
such as cornices, balconies, and luminous signboards. It is very impor-
tant to avoid the presence of all types of cables below the extended lift.
3.11 - Do not use stepladders on the lift or use it as a support for them.
3.12 - Before using the lift, check the condition of the cable. The cable
should not have broken threads or show any signs of crushed/flattened
areas. NEVER use faulty cables, always change them if there is any
doubt. Only use KUZAR steel cables; reference: DIN 3060.
Quality: 180KG/mm and torsion resistant.
3.13 - All sections must be lowered first, and the legs placed in its trans-
port position, before transportation.
3.14 - Do not grease or lubricate the winch's braking mechanism. The
brake disks have been greased with a special heat and pressure re-
sistant solution. Other products should not be used to avoid negative
effects regarding the braking mechanism.
3.15 - The minimum load to avoid problems regarding the braking me-
chanism is 25Kg. Without this load the brake will not work.
3.16 - NEVER take apart the crank of the winch when the lift is carrying
a load or extended.
KUZAR SYSTEMS S.L. 4