Antenna Installation; Setting The Camera Channel (Optional); Pairing The Camera To Receiver (Optional) - Voyager BARNVIEW1 Manuel

Antenna Installation

5dBi Antenna
3dBi Antenna

Setting the Camera Channel (optional)

The wireless camera is supplied preset to channel 1.
The monitor supports up to 4 cameras. Follow the steps below in Camera Setup section to
setup or change the monitor channel of the camera. If you are adding another camera to
link with the supplied monitor in this kit, then ensure its channel is set to a different
channel to the existing camera(s).

Pairing the Camera to Receiver (optional)

Follow the steps in Camera Setup section to setup or change the channel of the camera. If
you are adding another camera to link with the supplied monitor in this kit, then ensure its
channel is set to a different channel to the existing camera(s).