Voyager BARNVIEW1 Manuel page 34

TROUBLE SHOOTING
TROUBLE
No image
Poor picture quality
The motion sensor not
working
No recording happens
although it has the
schedule set.
Unable to pair the camera
to the receiver
A white image appears at
night
LIVE screen has no icons. Screen lock may be on. Tap the Power button to unlock the
System locked up
Unable to use the
Windows Media Player
to play the video
clips from the SD card
SOLUTIONS
Screen lock may be on. Tap the Power button to unlock the
screen.
Make sure the camera is powered on.
Make sure the monitor has enough charge / connect it to
AC/DC adaptor.
Move the camera closer to the monitor; it might be out of
range or move the antenna of the receiver to obtain best
possible reception.
Move the antenna of the receiver to obtain best possible
reception.
Clean the camera lens using lens cleaning cloth.
Increase or decrease the
(please refer to the Motion Detection section).
Check the settings on the RECORD screen.
Ensure correct DATE AND TIME has been set and the
Record Schedule setup correctly.
Ensure the memory card is inserted into DVR and formatted.
Make sure the camera is powered on.
Press and release the pairing button quickly. Do not press and
hold.
Power off the receiver and restart. If power button does not
respond, use a pin to press the reset button.
The camera's infra-red LEDs shine invisible light that reflects
off surfaces such as glass will cause white light. Place the
camera on the other side of windows to improve the night
vision or place it in a
security lamp to improve lighting).
screen.
Power off the receiver and restart. If power button does not
respond, use a pin to press the reset button.
The video files play with a Quicktime® player. Download
this free player from www.apple.com . You can also
download the alternative free player, VLC Media Player,
from www.videolan.org. Ensure your PC has SD card reader.
sensitivity of the motion sensor
well-lit area (recommend to install a