Safety Warnings - AGV SIDE SHARE EASY Manuel D'installation

Remove the protective film from the two-sided tape on the back of the keypad and stick the keypad
to the flat side of the adaptor. Keep pressed together for about 10 seconds.
he
Use a damp cloth to clean the surface of the shell where the keypad is to be glued.
Identify the area of the shell where the adaptor unit + keypad will be fitted and position the
ot
template as shown in figure 21.
Remove the protective film from the two-sided tape applied to the curved surface of the adaptor.
Glue the unit (keypad + adaptor) to the helmet and keep pressed together for about 10 seconds.
You can now remove the template.
ce
NB: The design of the keypad does not guarantee that it will work reliably if it is removed and then
fitted to another helmet.
nd
Before using a helmet fitted with the SHARE EASY OPEN FACE/FLIP UP system on the road.
nt
make sure that ALL the cables are outside the chin strap and are suitably concealed behind the
padding. Make sure that there are no loose cables or components that might cause bother while
you are riding.
or
We recommend that you wait several hours before using the helmet to allow the adhesive to set
properly.
SHARE has been designed to be safe and not to affect the normal fit of the helmet.
re

SAFETY WARNINGS:

ad
Overview
te
ne
Please read carefully the safety instructions regarding your headset, located in the enclosed
ne
Manual.
es
This manual is provided without a warranty of any kind. AGV Spa reserves the right to change this
manual, at any time and without prior notice, due to typographical errors, inaccuracies, updates of
information, or improvements to programs and/or equipment.
These changes will be incorporated in new editions of the publication on the site www.agv.com.
The user should consult the above website to check for changes and updates.
"The Share Intercom system complies with all the technical regulations applicable to the product
within the scope of applicability of EU directives
2006/95/EC, 2004/108/EC, and 1999/5/EC.
-
ETSI EN 301 489
-
ETSI EN 300 328
-
he
EN 60950-1
-
EN 61000-4-2
-
Users are not allowed make changes or variations of any kind to the device. Any changes or
eal
modifications not expressly approved by AGV Spa void the user's authority to operate the
equipment.
This Limited Warranty does not cover any consumables (such as batteries) supplied with this
ou
Product; cosmetic damages; damage or loss to any software programs, data, or removable storage
media; or damage due to, including but not limited, (i) acts of God, accident, misuse, abuse,
negligence, abnormal, or unusually heavy use, causes external to the Product such as but not
limited to excessive heat or humidity, or modifications of this Product; (ii) improper installation,
operation, testing or maintenance of this Product; (iii) power failure or connection to improper
voltage supply; or (iv) attempted repair by any party other than your authorized distributor or
17