AGV SIDE SHARE EASY Manuel D'installation page 14

Remove the expanded polystyrene inserts from the cheek pads (Figure 2)
Remove the plastic insert from the chin guard which fills the housing for the microphone (if present
on the helmet) and remove the expanded polystyrene inserts from where the earpieces will go.
If the use of stereo devices is not permitted in your country, disconnect the left earpiece connector
and put it back in the box (figure 3)
Position the Velcro strips on the units that house the electronics and the battery (figures 4a and 4b)
making sure that the surface of the strips is the right kind to stick to the Velcro already present on
the cutaways inside the helmet.
The plastic case with the microphone boom fits into slot A while the other case goes into slot B
(figure 5)
Remove the protective film from the Velcro discs and glue them into the cutaways in the helmet for
the earpieces. Make sure that the cables follow the routes shown in Figures 6a and 6b.
Position the perimeter cable between the two cutaways on the lower edge of the helmet and pass
them outside the chin strap. On some helmet models (e.g.: Stealth SV, S4 SV, Horizon e Skyline)
this cable can be passed under a fabric tab at the rear of the internal crown pad. On other models,
the cable can be concealed under the neck roll (e.g. the Strada model).
If necessary, use the adhesive strips supplied to fasten the cables in position (Figure 7)
Gently twist the microphone boom so that the arrow faces the mouth (Figure 8)
Reassemble the cheek pads.
When reassembling the chin guard, make sure that the keypad cable exits (Figures 9a, 9b, 9c)
Take the adaptor you need for your model of helmet. The marking on the flat surface will guide you
as to which adaptor you need. Do NOT stick the adaptor to the helmet yet.
001 DA530/Strada
002 Stealth SV, S4 SV, Horizon, Skyline, K-3 SV
Remove the protective film from the two-sided tape on the back of the keypad and and stick the
keypad to the flat side of the adaptor. Keep pressed together for about 10 seconds.
Use a damp cloth to clean the surface of the shell where the keypad is to be glued.
Identify the area of the shell where the adaptor unit + keypad will be fitted and position the
template as shown in figures 10a and 10b.
Remove the protective film from the two-sided tape applied to the curved surface of the adaptor.
Glue the unit (keypad + adaptor) to the helmet and keep pressed together for about 10 seconds.
14
NB
fitte
Be
tha
Ma
ridi
We
pro
SH
hel