AGV SIDE SHARE EASY Manuel D'installation page 16

To mount the REAR SHARE EASY kit on your helmet, follow these instructions.
Place the helmet upside down on a soft surface and make sure that it is stable. It is easier to fit the
kit to the helmet with the chin guard open (figure 11)
Unsnap and remove the foam cheek pads and the crown pad.
Do not under any circumstances try to remove the expanded polystyrene cheek pad bases. Do not
under any circumstances try to remove the expanded polystyrene chin guard.
Remove the EPS inserts in the expanded polystyrene protective padding (figure 12)
Remove the expanded polystyrene inserts for the earpieces.
If the use of stereo devices is not permitted in your country, disconnect the right earpiece
connector and put it back in the box (figure 13)
Position the Velcro strips on the units that house the electronics and the battery (figures 14a and
14b) making sure that the surface of the strips is the right kind to stick to the Velcro already present
on the cutaways inside the helmet.
Remove the protective film from the Velcro discs and glue them into the cutaways in the helmet for
the earpieces.
The plastic case with the USB cable fits into slot A while the other case goes into slot B. (figure
15)
Remove the protective film from the earpieces and position them in the polystyrene cheek pad
cutaways. The right earpiece should be positioned in such a way that the cable follows the route
shown in figure 16a. The left earpiece should be positioned in such a way that the microphone
boom follows the route shown in figure 16b. Fasten the earpiece connector in the polystyrene
cutaway (figure 16a) in such a way that it won't cause any bother when riding (only in countries
where the use of stereo devices is permitted)
Lock the microphone boom into position using the clip inside the shell (figure 17)
If necessary, use the adhesive strips supplied to fasten the cables in position (Figure 18)
Gently twist the microphone boom so that the arrow faces the mouth (figure 19)
Reassemble the crown pad and conceal the cable that connects the two plastic cases behind the
rear tab.
Reassemble the cheek pads taking care to route the keypad cable as shown in figure 20. Conceal
the USB cable between the crown pad and the cheek pad padding.
Take the adaptor you need for your model of helmet. The marking on the flat surface will guide you
as to which adaptor you need. Do NOT stick the adaptor to the helmet yet.
003 Numo, Numo Evo, Compact
16
Rem
to th
Use
Iden
tem
Rem
Glue
You
NB:
fitted
Befo
mak
pad
you
We
prop
SHA
SA
Ove
Plea
Man
This
man
infor
The
The
"The
with
-
-
-
-
-
Use
mod
equ
This
Prod
med
neg
limit
ope
volta