Description And Technical Specifications; Dimensions - FAAC 550 Mode D'emploi

ENGLISH
These instructions apply to the following models:
550 I - 550 Slave
The FAAC 550 automation system is designed to operate
residential counterbalanced up-and-over garage doors.
It consists of an electromechanical operator, a control unit
with courtesy light and a protective cover integrated into a
single unit to be mounted on the garage door panel using the
relevant accessories.
The irreversible system locks the door mechanically when the
motor is not running, so a lock is not required. A manual release
device allows the door to be operated in the case of a power
failure or malfunction.
Anti-crushing safety is assured by an adjustable electronic
device.
The 550 automation system allows two operators (550 I + 550
Slave) to be installed on the same door.
The 550 automation system has been designed and constructed
for vehicle access control. Do not use for any other purpose.

1. DESCRIPTION AND TECHNICAL SPECIFICATIONS

Cover
OPEN button
550MP control unit
Control unit box
Back plate
Drive shaft
Release device
Geared motor unit
Release key
AUTOMATION SYSTEM 550 & 550 MP
Fig. 1
TABLE 1 550 OPERATOR TECHNICAL SPECIFICATIONS
MODEL
Power supply
Power consumption (W)
Max. torque (Nm)
Angular velocity (°/sec)
Duty cycle (cycles/hour)
Temperature range
Geared motor weight (kg)
Housing protection
Max. door width (m)
Max. door height (m)
Max. door weight (kg/m 2 )
Clutch
Control unit
Geared motor dimensions LxHxD(mm)
Technical characteristics of electric motor
Speed (rpm)
Reduction ratio
Thermal cutout on winding
Power (W)
Current draw (A)
Surge capacitor
Power supply

2. DIMENSIONS

175
100
160
• values in mm
10
ENGLISH
550
230V~ (+6% -10%) 50Hz
360
300
12
15 (without limit switch)
25 (with limit switch)
-20 ÷ +55°C
13
IP 31
IP 44 (with Kit)
3 (1 operator)
4 (2 operators)
2.7 (1 operator)
3 (2 operators)
10
electronic
550MP
see fig.2
1400
1 :700
135 °C
350
1.5
8µF
230V~ (+ 6% -10%) 50Hz
50
120
Fig. 2