Two-Step Sawing; Safety; Maintenance; Environmental Protection - Rodia 4050TS Manuel D'utilisation

GB

Two-step sawing

• Adjust the saw head in its top position.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop.
• Hold the material with two hands while
making sure your hands are free from
the sawing blade.
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial and move the sawing table back-
ward in its initial position.
• Rotate the material and cut it through
completely.

8. SAFETY

Besides the valid safety regulations atten-
tion to the following items should be made:
• Carefully follow the directions of set-
ting up and working with the sawing
machine.
• Carefully check that the electrical con-
nections are correct.
• Electrical cables should not come in
contact with water or water spray.
• Damaged saw blades should be
replaced immediately.
• Secure material to be cut by hand dur-
ing sawing.
• Make sure your hands stay away as
far as possible from the rotating saw
blade.
• Wear protective goggles during saw-
ing.
• Wear hearing protection during saw-
ing.

9. MAINTENANCE

• The cooling water should be replaced
and/or replenished regularly.
• It is recommended to clean the water
4050TS-4060TS
RODIA ®
20
container, pump, hoses and spray noz-
zle on a regular basis. For example,
place the pomp in a bucket of clean
water after the sawing job and run the
machine for a minute or so. This also
guarantees a longer lifetime of the
pump.
• When the machine is not used for a
longer period, the pump should not
remain in the muddy cooling water.
Cleaning the pump as described
above and leaving it outside the water
container is better.
• Regularly check the V-belts for wearing
and tension. If necessary replace worn
belts.
NOTE!
Always replace belts in sets.
• Regularly check the saw flanges for
wearing out and replace if necessary.
10. ENVIRONMENTAL
PROTECTION
Do not dispose of the appliance
with domestic waste. Dispose of
the appliance only via an author-
ized waste management com-
pany or your municipal waste
management organisation. Adhere also to
the applicable regulations. In case of
doubt refer to your waste management
organisation. Recycle all packaging mate-
rial in an environmentally friendly manner.

11. TROUBLESHOOTING

For malfunctions that are not specified in
this chapter, when in doubt or when explic-
itly indicated, seek assistance from an
authorized service facility.