Fermax 2532 Manuel D'installation page 19

NOTE: In case
number to be programmed consists of four digits (the first 2 correspond to the block number
and the last 2 to the apartment number), whereas in the case of the panel decoder it consists
of three digits.
NOTE: This option is not valid for panel decoders.
and in the lower line, the number of the telephone
or panel currently programmed in the first output of
the decoder.
2. Enter a new number (if you want to change) and
press <B>.
3. Repeat this last step for the remaining outputs of
the decoder.
of AUDIO-4,
2- Sequential Programming
To programm sequentially the numbers of telephones
connected to one or more decoders. Once this option
has been selected, the steps to follow are:
1. Enter the number corresponding to the telephone
connected to the first output of the first decoder to
be programmed and press <B>.
2. Press the programming button of this decoder (See
installation instructions of the decoder). The system
will automatically assign correlative numbers to the
outputs.
3. Press the programming button of the next decoder
to be programmed. The system will assign
correlative numbers starting from the last number
programmed in the previous decoder.
4. Press <B> to end the sequence.
3- Change of code
Allows to change the number assigned to a given
decoder output. Once this option has been selected,
the steps to follow are:
1. Enter the current number and press <B> to validate
it. If it does not exist, an error message will be
generated. If it does exist, you will be asked to enter
the new number.
AUDIO-8 and ISO decoders, the
Page 7