Transport, Packaging And Storage - WIKA IL-10 Mode D'emploi

4. Transport, packaging and storage

4. Transport, packaging and storage
4.1 Transport
Check the submersible pressure transmitter for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
4.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation site, sending for
repair).
4.3 Storage
If the protection cap is not mounted, it should be mounted for storage so that the diaphragm will not be damaged.
Permissible conditions at the place of storage:
Storage temperature: See chapter 9 "Specifications"
Avoid exposure to the following factors:
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Store the submersible pressure transmitter in its original packaging in a location that fulfils the conditions listed above.
If the original packaging is not available, pack and store the instrument as described below:
1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument, along with shock-absorbent material, in the packaging.
WIKA operating instructions submersible pressure transmitter model IL-10
EN
15