Transport, Packaging And Storage - WIKA NS100 Mode D'emploi

5. Transport, packaging and storage

5. Transport, packaging and storage
5.1 Transport
Check pressure gauge for any damage that may have been caused by
transport.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during trans-
port (e.g. change in installation site, sending for repair).
5.3 Permissible storage temperature
Model 2, PG23CP:
„
Model PG23LT:
„
WIKA operating instructions pressure gauge, model 2 per ATEX
-40 ... +70 °C
-70 ... +70 °C
EN
13