Design And Function; Scope Of Delivery; Transport, Packaging And Storage - WIKA O-10 Mode D'emploi

4. Design and function / 5. Transport, packaging and storage

4. Design and function

4.1 Description
The prevailing pressure is measured at the sensor element through the deformation of a diaphragm. By supplying
power, this deformation of the diaphragm is converted into an electrical signal. The output signal from the pressure
sensor is amplified and standardised.

4.2 Scope of delivery

Cross-check scope of delivery with delivery note.

5. Transport, packaging and storage

5.1 Transport
Check the pressure sensor for any damage that may have been caused during transportation.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation site, sending for
repair).
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature O10 (T): -30 ... +100 °C
Storage temperature O10 (5): -25 ... +80 °C
Only ever store the pressure sensor in its original packaging.
WARNING!
Before storing the instrument (following operation), remove any residual media. This is of particular
importance if the medium is hazardous to health, e.g. caustic, toxic, carcinogenic, radioactive, etc.
WIKA operating instructions pressure sensor, model O-10
EN
21