General Description - Dantherm HAC 1 Manuel De Service

General description

Introduction
Functions
16
This accessory controller (HAC 1 in the following) is designed for the accessory program
for Dantherm Air Handling HC Home Ventilation product range.
During installation and calibration of the accessories it is necessary to have a Dantherm
Air Handling A/S remote control (HRC 2). In most cases the remote controller is also
necessary for the house owner/occupant during normal use.
The local Dantherm installer can provide the HRC 2 remote control and all the other ac-
cessories mentioned in this installation instruction.
The HAC 1 controller is prepared for the following plug-in accessories
Heaters, water based or electrical

Coolers

GTC (Geothermal collector)

CO Sensor

2
Standby switch/ digital input

Dampers

Hygrostat, boost function

Alarms outputs

Fire thermostat

Modbus
