Before The First Use; Filling The Water Tank - Di4 Jet Pressing Pro 5b Mode D'emploi

Proceed according to the conservation and cleaning section of this manual for cleaning
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.

BEFORE THE FIRST USE

Before using the Steam Station, please ensure you read the user manual and understand all parts
and features of the Steam Station. Be sure to remove any packaging material and labels before using
for the first time.
In the first use they can break off odors or fumes that sent quickly. Do not spray for the first time on
clothes and there may be traces of dirt on the soleplate
WATER TO BE USED
The device is designed for use with tap water. If the water in your area is hard or semi-hard use mix
tap water with distilled or demineralized water purchased in stores, in the ratio 2: 1 and 1: 1 respec-
tively. Check with your water supplier to determine the type of water in your area.
Never use 100% distilled or demineralized, rain water, softened water, scented water, water from oth-
er appliances such as refrigerators, air conditioners, dryers or other types of home water preparation
water.

FILLING THE WATER TANK

Locate the water tank release latch under the front of the water tank and push up. This will release the
water tank, enabling you to pull it out.
Place the water tank inlet under a tap and fill. Do NOT fill over the MAX level indicator.
Slide the water tank back in position and push in, you will hear it click when it is locked in place.
OPERATING INSTRUCTIONS
1. Place the Ironing Centre on a completely flat table, bench or ironing board, firmly positioned on
the surface.
2. Connect the unit to the power outlet and turn the switch to the 'on' position.
3. Make sure the steam button is unlocked.
4. Turn the power switch knob to the right to connect the unit. The pilot light will turn on.
5. The Ironing Centre will begin to heat the water.
NOTE: ou will hear water being pumped from the water tank to the water boiler. This is a normal
function, and always occurs when there is no water left in the Ironing Centre. DO NOT push the steam
button while the Ironing Centre is heating up.
6. Once the unit is ready for use, the steam status indicator light will turn red.
7. You may now start ironing. Move the iron's temperature control dial to adjust the heat to the type
of material to be ironed.
Check the Ironing Guide Table in this manual if you need more information regarding recommended
ironing temperatures.
NOTA: Upon ironing, the thermostat light will intermittently turn on and off as the temperature
changes.
19