Cleaning And Maintenance - Arwin Tools AGS44 Traduction De La Notice Originale

into the collection box without blocking the
outlet.
6. The ventilation opening must not be locked by
the shredded material.
7. Continuous shredding of thick wood or
branches can cause the machine to jam.
8. Soft material like leaves or sprigs can easily
block the inlet ;use a push stick to poke it in.
9.Always check litter for nails and stones before
shredding as they can seriously damage the
shredder.

7. CLEANING AND MAINTENANCE

Before commencing cleaning and
maintenance procedures, make sure the
garden shredder is switched off and disconnected
from the mains supply. Always wear sturdy
leather gloves when cleaning the cutter blades.
To ensure the best performance from the garden
shredder, it must be kept clean.
1. Always clean the garden shredder immediately
after use.
2. Do not allow material to because dry and hard
on any of the garden shredder surface. This will
directly affect the shredding performance.
3. Make sure that the inlet chute and the ejector
chute are kept clean and clear of all waste
material.
4. Make sure that all nuts, bolts and screws are
tight and secure.
5.Always have any damaged or worn parts
repaired, or replaced by qualified personnel.
6. Do not use detergents or solvents as these
could cause irreparable damage to your machine.
Chemicals can destroy the plastic parts.
ADJUSTING THE COUNTERPLATE
To obtain an optimum shredding result and
prevent damage to the blade, the counterplate
must be adjusted at regular intervals. The
counterplate must also be adjusted of so called
interlinkage occurs.
1. Turn Counterplate Adjusting Knob (5) clockwise
until a slight friction noise can be heard and fine
aluminum chips fall from the ejector chute for a
18
short period of time. (B3a and B3b)
2.Then. the materials to be shredded should be
fully cut again.
CAUTION
Remove dirt and material residues after every use.
Do not clean the machine with running water or
high pressure.
Do not use any cleaning agents or solvents.
Use a soft brush or cloth for cleaning.
REPLACE COUNTERPLATE
1. Open the back cover by loosing 4 Screws (A).
(B4a)
2. Take out the Counterplate (B) and replace a
new one. (B4b)
3. Put back the back cover and use wrench to fix
the screws.
8. ENVIRONMENT
Should your appliance need replacement
after extended use, do not dispose of it
with the household refuse, but in an
environmentally safe way.
Waste produced by electrical machine items
should not be bandled like normal household
rubbish.
Please recycle where recycle facilities exist. Check
with your Local Authority or retailer for recycling
advice.
Have your garden shredder inspected and
maintained by qualified service personnel.
Do not attempt to repair the machine unless you
are qualified to do so.
WARNING : Never use a high-pressure
washer or running water when cleaning the
shredder ! Brush away dirt and plant residues
which may be caught in the spiral cutter.
Wipe clean the outside of the shredder with a
cloth which has been moistened with a mild
detergent and water.