Preparation - Arwin Tools AGS44 Traduction De La Notice Originale

tools etc in accordance with these instruc-
tions. Take the working conditions and the
tasks to be completed into account.The use of
electrical tools for tasks other than the one they
are intended for can lead to dangerous situations.
1.3 Service
• Only have your electrical tools repaired by
qualified specialists and with original replacement
parts.This ensures that the safety of the electrical
tool is maintained.
• Before conducting any maintenance, make sure
the device is unplugged (disconnect the
power supply) and wait until the blade shaft is
at a complete standstill. Allow the device to cool
down before doing anything.
• Only those maintenance and fault elimination
tasks described here, may be carried out. Any
other tasks must be completed by a specialist.
• Check all screws regularly to ensure that they sit
tight.
• Conversions, independent modifications and the
use of non-approved parts are not permitted.
• Only use original replacement parts. Only these
replacement parts are designed and suitable
for the device. Other replacement parts will not
only lead to an invalidation of the guarantee,
they may also endanger you and your
environment. Always store the device in a dry
location.
• If the machine is switched off for the purpose of
maintenance, storage or to replace an acces-
sory, ensure that the plug has been pulled from
the socket. Ensure that all of the moving parts
have come to a standstill and, if there is a key,
remove it. Allow the machine to cool down
before carrying out maintenance, adjustment
work etc.
• Always allow the machine to cool down before
storing.
• Never transport the unit with the engine
running. Protect the device from becoming
damaged during transportation.

2. PREPARATION

1. Before starting the machine, look into the
feeding chamber to make certain, that it is empry.
2. Keep proper balance and footing at all times.
Do not over reach. Never stand at a higher level
than the base of the machine, when feeding
material into it.
3. Always stand clear of the discharge zone when
operating this machine.
4. When feeding material into the machine be
extremely careful that pieces of metal, rocks,
bottles,cans or other foreign objects are not
included.
5. If the cutting machanism strikes any foreign
objects or if the machine should start making any
unusual noise or vibration, shut off the power
source and allow the machine to stop, dicconnect
the plug(electric unti disconnect from supply)and
take the following steps :
a) Inspect for damage.
b) Check for and tighten any loose parts
c) Have any damaged parts replaced or repaired
with parts having equivalent specifications.
6. Do not allow processed material to build up
in the discharge zone ; this may prevent proper
discharge anc can result kickback of material
through the feed intake opening.
7. Keep all guards and deflectors in place and in
good working condition.
8. Do not transport this machine while the power
source is running.
9. Shut off the power source and disconnect
the plug(electric unti disconnect from supply)
whenever you leave the work area.
10. Do not tilt the machine while the power
source in running.
11. Motor should be kept clean of debris and
other accumulations.
Description of symbols
Read the uesr manual fefore using the
machine.
15