Set The Clock; Set The Alarm Timer - Grundig MS 300 Mode D'emploi

SETTINGS __________________________________

Set the Clock

1 In Standby mode, press and hold CLOCK
button.
2 Press the / buttons on the remote control
to select 12/24 hour format, then press the OK
button on the remote control to confirm. The hour
digits will flash.
3 Press the / buttons on the remote control
to adjust the hour digits while flashing, then press
the OK button on the remote control to confirm.
Then the minute digits will flash.
4 Press the / buttons on the remote control to
adjust the minute digits while flashing, then press
the OK button on the remote control to confirm.
Note:
• Each activated state will be cleared if any
buttons are not pressed within 15 seconds.
Time Display
• Press the CLOCK button to show the current
time on the display for a few seconds.

Set the alarm Timer

• The clock must be correctly set for the timer to
operate correctly.
1 In Standby mode, press and hold ALARM
button. Then the hour digits flash.
2 Press the / buttons on the remote control
to adjust the hour digits, and then press the OK
button on the remote control to confirm, the
minute digits will flash on the display.
3 Press the / buttons on the remote control
to adjust the minute digits, and then press the OK
button on the remote control to confirm, the mode
will flash on the display.
4 Press the / buttons on the remote control to
select:
- BUZZER (to wake to a buzzer sound)
- FM (to wake your selected FM Radio Station)
- DISC (to wake to your CD music)
- USB (to wake to your USB music)
38 ENGLISH
5 Press the OK button on the remote control to
confirm, the display will show the volume level.
6 Press the / buttons on the remote control
to adjust the volume, and then press the OK
button on the remote control to confirm,
show on the display.
Activate and Deactivate the Alarm Timer
• After setting the alarm timer, press the ALARM
button on the remote control to view the alarm
settings.
• The alarm is active when
display.
• To deactivate the alarm, press the ALARM
button twice. The
display. Press the ALARM button twice again
to activate the alarm timer.
• When the alarm rings, press the SNOOZE
button on remote control. The alarm repeats
ringing 9 minutes later.
• When the alarm rings, press
off the alarm.
Tips:
• Each enabled state will be cleared if a button
is not pressed within 15 seconds.
• When the alarm rings, press the
the remote control or on the unit. The alarm
stops but the alarm settings remain.
Set Clock/Alarm while in ON mode
1 In ON mode, press MENU button on the
remote control to entering system menu setup.
2 Press / buttons on the remote control to
select CLOCK or ALARM setting, and then press
OK button to confirm.
3 Press / buttons to setup and confirm with
OK button.
will
is shown on the
will disappear on the
button to turn
button on