Setting The Clock; Programming­radio­stations - Grundig MS240 Mode D'emploi

SETTINGS
Setting­the­clock
The first time you connect the hi-fi system to the
mains, it switches to standby.
1 In standby mode, press and hold »PROG« on
the remote control for 2 seconds.
H« or
– Display: »12
2 Press » « or »
3 4
» « or » « on the remote control to select
5 6
the hour format (12 or 24 hours) and confirm
with »PROG«.
– Display: The clock digits for the hours flash.
3
Select the hours with »
hi-fi system or with »
control and confirm with »PROG«.
– Display: The clock digits for the minutes flash.
4
Select the minutes with »
the hi-fi system or with »
mote control and confirm with »PROG«.
– Display: the current time.
Tuning­and­storing­radio­stations
You can store up to 30 stations in the FM
frequency range on presets.
Note:
For the best FM (VHF) reception, it is sufficient
7
to direct the wire antenna accorddingly.
Programming­radio­stations
1
Switch on the hi-fi system from standby mode
by pressing » 8 « or »SOURCE«.
2 Select the input source TUNER by pressing
»SOURCE« on the hi-fi system or by pressing
»TUNER« on the remote control.
3
Set the radio station by briefly pressing »
or » « repeatedly.
4
– Display: the frequency changes in steps of
50 kHz;
or
press and hold down »
the frequency changes to rapid run-through.
­ - --------------------------------------------------------------------------------------------------------------------------------------
H«.
»24
« on the hi-fi system or
« or » « on the
3 4
« or » « on the remote
5 6
« or »
3 4
« or » « on the re-
5 6
3
« or » « until
3 4
4 To store the radio station, press »PROG«,
select preset by pressing »+­PRESET­-« on the
hi-fi system or by pressing » « or » « on the
remote control and confirm with »PROG«.
5 To search and save more radio stations, repeat
steps 3 to 4.
« on
«
21­
ENGLISH