Kemper variohood 232 03 02 Mode D'emploi page 21

Step 11 - Placing the perforated metal rail
Push the intermediate profile with the corner joints into the frame of the extraction hood. Screw the corner joints.
Step 12 - Attaching the end cap
Attach the end cap to the intermediate profile. Use a countersunk bolt for an upper drill hole. Use an eye bolt for the other drill hole. With this the
hood can be suspended from the ceiling.
Use two countersunk bolts below.
Step 13 - Placing the upper metal rail
Keep the upper metal rails handy. Proceed as described above.
Now attach the upper rails to the lower rails.
Please note: If the hood is set up on supports, ignore this step and go to: "Setting up with supporting
stands", step 2.
19