Publicité
Les langues disponibles
Les langues disponibles
forth. If you want delete the function TIMER you must press the
"Timer" key until on the panel will show NOT light function.
- room temperature: keeps room temperature constantly at the set
value. Temperature range between 10 and 49°C is selected using
only the remote control, press "Mode" key, if pressing either the "+"
or "-" key to increase or reduce the temperature shown on the
display at the time
- Example: if we want temperature at 30°C, you must select the "+" key
until on the LCD show 30°C, then the 30°C flash for some seconds,
and then the LCD show the effective temperature of the room
temperature, then some time the temperature will increase and on
the LCD will show the room temperature updated until at 30°C. When
on the LCD will show 30°C, the appliance always function, but will
decrease the out power. The appliance will start automatically to
function when the temperature decrese on the room temperature.
- For delete the function room temperature you must press the
"cancel" key on the remote control.
The control panel has a series of luminous LEDs, each to indicate the
functions selected and on the LCD show the room temperature.
To use the heater, act as follows:
1) Insert the plug into the socket.
2) Switch on the main switch (pos."I").
3) Select the function required by following the instructions given
above: when the fan is switched on, the front grid opens automatically
to maximum aperture.
4) To switch off the fan heater, run just the fan
to cool the resistance (in this way it will have a longer life); press the "
" key of the remote control or of the keyboard.
At the end of use, completely switch off the appliance using the main
switch (pos."0") located on the side.
For long periods of inactivity, remove the plug from the power socket.
CLEANING AND MAINTENANCE
Attention: before cleaning the appliance, switch off, unplug and
wait for before it has completely cooled down.
• To clean the body use a soft damp cloth; do not use abrasive
products.
• Do not submerge any part of the heater in water or other liquids; if
this should happen, do not put your hands into the liquid, firstly
remove the plug from the power socket. Carefully dry the appliance
and check that all the electrical parts are dry: if in doubt, contact
professionally qualified personnel.
for around 3 minutes
20
Publicité
