Cleaning And Maintenance - Bimar CPH-09 Mode D'emploi

 Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
 The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
edges, nor wrapped around the device or twisted.
Portable installation
In order to use the appliance the two feet supplied must be fitted to the same by operating as follows:
- Always unplug the appliance before you assemble.
- Put the appliance down horizontally on a flat, smooth surface.
- Put the free standing feet onto ground, keep the slots of both foot
from either side to the relevant foot is recommended; then insert the panel into the slots lightly.
- Screw the two bolts into the holes on the feet
 In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
USE
Each time before use, check that the appliance is in good state, that the electric cord is not damaged:
in case of doubt, do not use it but contact a qualified technician.
When using for the first time
Attention: to operate the panel heater, to eliminate the "new smell" and any residual oils for
processing at least a few hours. During this operation, ventilate the area in order to eliminate the smell
"new" that emanates from the panel.
To use the panel heater, act as follows:
1) Insert the plug into the socket.
2) Switch on the main switch (pos."I").
3) At the end of use, completely switch off the appliance using the main switch (pos."0") located on
the side.
For long periods of inactivity, remove the plug from the power socket.

CLEANING AND MAINTENANCE

Attention: before cleaning the appliance, switch off, unplug and wait for before it has
 To clean the body use a soft damp cloth; do not use abrasive products.
completely cooled down.
 Do not submerge any part of the heater in water or other liquids; if this should happen, do not
put your hands into the liquid, firstly remove the plug from the power socket. Carefully dry the
appliance and check that all the electrical parts are dry: if in doubt, contact professionally
 If you decide not to use the appliance any more, we recommend making it inoperative by
qualified personnel.
cutting the power cord (after making sure you have disconnected the plug from the socket) and
make dangerous parts harmless if children are allowed to play with them.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH EC DIRECTIVE 2011/65/EU.
At the end of its working life, the product must not be disposed of as urban waste. It must be taken to
a special local authority differentiated waste collection centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative consequences for the
environment and health deriving from inappropriate disposal and enables the constituent materials to
be recovered to obtain significant savings in energy and resources. As a reminder of the need to
collinear, distance as 5-7cm
13/40