Specific Safety Rules - Makita BTW250 Manuel D'instructions

ENGLISH
1 Red part
2 Button
3 Battery cartridge
4 Switch trigger
5 Lamp
6 Reversing switch lever
7 Socket
8 Anvil
SPECIFICATIONS
Model
Capacities
Square drive
No load speed (min
Impacts per minute
Max. fastening torque
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for fastening bolts and nuts.
Safety Hints
For your own safety, please refer to the enclosed safety
instructions.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to impact wrench safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious per-
sonal injury.
1. Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord. Con-
tact with a "live" wire will make exposed metal parts
of the tool "live" and shock the operator.
2. Wear ear protectors.
3. Check the socket carefully for wear, cracks or
damage before installation.
4. Hold the tool firmly.
5. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6. The proper fastening torque may differ depend-
ing upon the kind or size of the bolt. Check the
torque with a torque wrench.
SAVE THESE INSTRUCTIONS.
Explanation of general view
9 Pin
10 O-ring
11 Hook
12 Screw
13 Groove
14 Fastening torque
15 Proper fastening torque
16 Fastening time
Standard bolt
High tensile bolt
–1
)
GEB009-2
17 Limit mark
18 Rear cover
19 Screws
20 Spring
21 Arm
22 Recessed part
23 Carbon brush cap
24 Hole
BTW250
M10 – M16
M10 – M14
12.7 mm
0 – 2,200
0 – 3,200
230 N•m
165 mm
1.6 kg
D.C. 14.4 V
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
IMPORTANT SAFETY INSTRUCTIONS FOR
BATTERY CARTRIDGE
1. Before using battery cartridge, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using bat-
tery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any conduc-
tive material.
(2) Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.
(3) Do not expose battery cartridge to water or
rain.
A battery short can cause a large current flow,
overheating, possible burns and even a break-
down.
6. Do not store the tool and battery cartridge in
locations where the temperature may reach or
exceed 50°C (122°F).
BTW251
M10 – M16
M10 – M14
12.7 mm
0 – 2,100
0 – 3,200
230 N•m
165 mm
1.7 kg
D.C. 18 V
ENC007-2
5