KPS PA70 Manuel D'instructions page 43

KPS-PA70 • Digital clamp meter
In Voltage Measurement Mode:
Electric shock hazard. Pay special attention to avoid shock when mea-
suring high voltage. Don't input voltage more than AC 750 RMS.
1) Insert black probe to COM jack, insert red probe to INPUT jack.
(2) Place transfer switch to CA V or mV position. press FUNC to enter AC volt-
age measurement state.
(3) Press "Hz/%" key to switch to frequency measuring state.
(4) onnect the probe with signal or both ends of load in parallel for measure-
ment.
(5) Read on the LCD.
(6) Pressing "Hz/%"again can enter duty ratio measurig state.
Note:
(1) Frequency measurement range is 10Hz~1kHz When the frequency to be
tested is less than 10Hz,the LCD will show "00.0"Masuring frequency higher
than 10 kHz is possible, but ccuracy is ot guarantee
(2) Duty ratio measuring range is 10 ~ 95%.
(3) " " means that maximum input voltage is 750V AC (RMS).
In HZ/DUTY Measurement Mode:
Electric shock hazard. Pay special attention to avoid shock when mea-
suring high voltage. Don't input voltage more than AC 250V RMS.
(1) Insert black probe to COM jack, insert red probe to INPUT Jack.
(2) Transfer switch is placed to position HZ.
(3) Connect the probe with sinal or both ends of load in parallel for measure-
ment.
(4) Read on the LCD.
(5) Pressing "Hz/%" again can enter duty ratio measuring state.
Note: Frequency measurement range is 10Hz~1kHz When the frequency to
be tested is more than 10Hz,the CD will show 0.0measuring frequency higher
than 10 kHz is possible, but accuracy is not guarantee.
WARNING
WARNING
43